Logo

C0851 Engine Code Repair

Meaning of C0851 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C0851 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for C0851 code is occuring now you should check C0851 repair processes.
Now don't ask yourself; What should you do with C0851 code ?
The solution is here :

C0851 Possible Solution:

C0851 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

C0851 Code Meaning :

C
OBD-II Diagnostic Chassis (C) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

8
Fuel Rail Pressure Sensor Circuit Malfunction

5
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

1
Shift Solenoid E Performance or Stuck Off

Regarding the C0851 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

C0851 OBD-II Diagnostic Chassis (C) Trouble Code Description

C0851 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For C0851 Code

The reason of C0851 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

Parts or components should not be replaced with reference to only a C0851 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.